Move over Pete, Maggie's earned a seat in the same pew. Clif - you coulda, woulda, shouda installed em' first thing. As to the manual, just...
Pete was slam on - Page 31 of your manual references "theoretical" SATA speeds of 150mbs but is hazy re: actual. Your regular IDE headers are...
Pete - right on the money. At least right church, perhaps wrong pew (but I think you nailed it with not supported). However, if his MB does...
Thanks RMA - I bookmarked that puppy - nice find, much appreciated. ;)
Nice piece of research Zander. Those Dude's are a pain in the butt, Huh? I've run into this before and its not that tough, but to the...
You may need to look up the specific connectors on your Dell Power Supply because they have used a lot of non-standard wiring despite using a...
Don't know that board in particular but a lot of front panel audio setups from the motherboard not only have headers for connectors, but a...
Hate to be the bearer of bad news but I guess you already know you have problems. My suggestion would be to slave that drive in another machine...
Then don't worry about it - Sheesh! They are all backwards compatable - much ado about nothing. :rolleyes:
Stuart: Sounds like you have a memory or memory timing problem to me. Best single source reading I'm aware of is here Yup! Even though you say...
David: You can do anything you want to do. I'm certainly no "end all" - other folks may have other ideas. There's not necessarily any "first...
No reason you can't get your son to help you do the above (my previous post) in the meantime - point being, you want to isolate and identify the...
Very high probabilty there will be a jumper on the MoBo for disabling on-board video - where is it? - now, thats another matter. You're going to...
Yes, most definately does. I think what we are all wondering is what would happen if you leave Drive 0 as it is and then connect Drive 1 to a...
No Pints left in Staffordshire? ;)
Could you have been mistaken? I didn't see the spring listed in your moniker. :rolleyes:
Can't believe what I'm reading. Just plug it in and go? hehehe .......... nothing could be further from the truth. You need to partition and...
You have me a little confused. Lets rehash - drive 0 was your IBM and contained your Operating System, Drive 1 (unknown) had partitions D & E and...
Rex: Did you change your refresh rate too? If yes, boot into safe mode a startup and drop it back down to a minimal refresh rate setting or...
Little higher degree of difficulty :eek: Could probably be answered better in networking forum but as you are aware, DSL Reports Speed tests...
Separate names with a comma.
