Tony: Thanks for the clarification but I got the 4% transfer compared to the pigeon's flight and the subsequent data transfer. I think I'm...
Interesting article. Of note, it mentioned nothing of "dropped packets" so we should be able to assume that all ground observers were also spared...
Look here for 2.5" drive cases. If you want to mount the drive internally, you'll need a 40 to 44 pin adapter (assuming this is an IDE drive). ;)
JMagradey: I'm not trying to open up a can of worms but I would question any direct or casual relationship between your reported password...
Meaning Husband. ;)
gabieke, I am familiar with the instruction set you referenced following the word Alternative and this has been posted on the BBS before. This...
System Setup is your BIOS. One can usually configure an administrator password, a user password or neither. This permits or blocks access to the...
Atta Boy Hawk - setting the record straight. Lar, you have to stick with DDR as Hawk has so clearly pointed out. DDR2 isn't going to work on your...
Check for two things in particular. If using SATA HDD, you may need to load SATA controller drivers at the prompt (press F6 to load...
I have no arguement with Arie's comments above and that is the official Microsoft policy as stated. I will however add that Microsoft can be a...
If memory serves me correctly, you should be able to use the disc you are trying to install from. Eject it, reinsert it and try it. If it takes,...
No, you won't be able to get past the Genuine Advantage Nag unless you have an illegal crack. You could try to find a decommissioned Dell with a...
Yes there is but I think your best course of action is to return it. ;)
Ctrl+alt+esc ? ;)
Great news Larry - my only regret is that I didn't check the board for new posts before retiring last night and had to wait until this morning to...
That lengthy explanation contained a lot of good information and is most appreciated. Being the curious type, I always like to understand the whys...
Sure. I've encountered boards before where CMOS couldn't be cleared unless the main power connector was disconnected when re-jumpering so this...
Lar Page 2-17 of your manual disagrees with you re: your CMOS jumper setting. It also says to pull the battery and jumper 2&3 to clear CMOS....
I'll disagree. ;)
Yes, Hawk has summarized it quite well. There is an actual setting for 400 in the subtab I mentioned. Also, if you are having problems or were...
Separate names with a comma.
