1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

Need to connect two sites

Discussion in 'Networking (Hardware & Software)' started by ramon82, 2013/01/29.

  1. 2013/01/29
    ramon82

    ramon82 Inactive Thread Starter

    Joined:
    2008/08/07
    Messages:
    66
    Likes Received:
    0
    Need to connect two sites

    Hi all

    Please refer to http://img248.imageshack.us/img248/2425/topology.jpg

    As you can see I configured SITE A and can easily access SITE B over an ADSL connection. The teleworker at SITE B is situated in a different geographical location and is obtaining the IP from the router at SITE A.

    My query is this: How can I configure SITE C to connect to SITE A and subsequently to SITE B without changing the IP schemas of both sites?. I know I should insert a router between the modem and the network switch in SITE C and setup NAT? Your help is greatly appreciated!

    Thanks
     
    ramon82,
    #1
  2. 2013/01/30
    TonyT

    TonyT SuperGeek Staff

    Joined:
    2002/01/18
    Messages:
    9,072
    Likes Received:
    400
    How is Site B getting its IP fro Site A? Is Site B's modem in Bridged mode?

    If Site B and Site A can communicate then just duplicate Site B on Site C.
     
    TonyT,
    #2


  3. to hide this advert.

  4. 2013/02/02
    elcajongunsfan Lifetime Subscriber

    elcajongunsfan Well-Known Member

    Joined:
    2012/01/01
    Messages:
    384
    Likes Received:
    14

    If these are WAN connected, use a wan protocol, the current one being MPLS
     
    Last edited: 2013/02/02
    elcajongunsfan,
    #3

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...