1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

Increase FSB result "PC" died ..........

Discussion in 'PC Hardware' started by Hossam, 2002/01/08.

Thread Status:
Not open for further replies.
  1. 2002/01/08
    Hossam

    Hossam Inactive Thread Starter

    Joined:
    2002/01/07
    Messages:
    38
    Likes Received:
    0
    i have a celeron 1.2GHz & mobo GA-6OXT

    i try to increase the frequency of FSB from 100 to 128 but the computer hang in the post "booting"

    my pc not response i try

    - use the jumper of clear cmos

    - pickup the cpu , AGP

    - try another cpu

    - restart the machine

    - use another power supply , monitor, AGP card ...

    what shal i do now

    plz help me
     
    Hossam,
    #1
  2. 2002/01/09
    AcaCandy

    AcaCandy Inactive

    Joined:
    2002/01/09
    Messages:
    25
    Likes Received:
    0
    If you have more than one ram chip, try pulling out any extras.
     
    AcaCandy,
    #2


  3. to hide this advert.

  4. 2002/01/09
    deuce

    deuce Guest

    Celerons are usually hard to o/c at that high a fsb. If you are trying to o/c you celeron you should start back at 100 and go up slowly... or did you do that already?... and also have more cooling and did you check if it needs a higher voltage?


    Candy... bummed you don't get your mulderator privileges over here?
     
    deuce,
    #3
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...