1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

Home Network and Zone Alarm

Discussion in 'Networking (Hardware & Software)' started by barryr2, 2005/02/27.

Thread Status:
Not open for further replies.
  1. 2005/02/27
    barryr2

    barryr2 Inactive Thread Starter

    Joined:
    2005/02/19
    Messages:
    15
    Likes Received:
    0
    Hello,

    I have a Home Network of 2 Desktops and 1 Laptop.
    All 3 computers are networked and shared one Dial Up Internet Connection.
    All worked fine until I installed Zone Alarm on the Host Computer.
    Obviousely, the host has internet access, while the other computes cannot get on the internet.

    Can anyone out there help me to properly set Zone Alarm, to allow the other computer Internet access as well?

    Any help is greatly appreciated.

    Barry :confused:
     
  2. 2005/02/27
    ecross

    ecross Inactive

    Joined:
    2005/02/01
    Messages:
    137
    Likes Received:
    0
    ZoneAlarm should have a way to configure the ip address that the machines are assigned to the Trusted Zone. Go into ZoneAlarm to see if you can configure it so it isn't blocking access between the machines on the network. Also, have a look here.

    Ping works only in ONE direction
    http://www.wown.com/j_helmig/noping.htm
     

  3. to hide this advert.

Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.