1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

Another H/D install question

Discussion in 'PC Hardware' started by Blufx, 2003/02/07.

Thread Status:
Not open for further replies.
  1. 2003/02/07
    Blufx

    Blufx Well-Known Member Thread Starter

    Joined:
    2002/02/03
    Messages:
    399
    Likes Received:
    0
    I'm helping a friend fix his notebook. It's a about a 1990 NEC pc 6100. He told me someone replaced the h/d and the system never recognised it. It does. I booted it and it told me bios checksum was wrong.....load default, which I did, then it told me the partition was corrupt or does not exist....run Phdisk. Now, is phdisk the same as fdisk? How do I do this?


    Thanks,Mark
     
    Blufx,
    #1
  2. 2003/02/07
    Blufx

    Blufx Well-Known Member Thread Starter

    Joined:
    2002/02/03
    Messages:
    399
    Likes Received:
    0
    H/D jumpers

    I pulled the h/d to check the jumper settings. The chart says...device 0(no jumper), device 1(one vertical jumper), cable sel(one horizonal jumper). It's set on cable select,which is wrong, I think. Do I change it to device 0?
     
    Blufx,
    #2


  3. to hide this advert.

Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...