boot up problem

Computer worked fine last night.This morning at startup the screen has this message : "Checking NVRAM" and nothing happens.I can even get to the Bios.Also no beep.

Jerry

 

Sounds like maybe a memory problem Jerry
have you maybe disturbed anything in the case ?
I suggest you take your ram out and re-seat it carefully to make sure its well seated and try again
Take care tosupport the motherboard if you have to press hard by inserting a strip of cardboard beneath the edge of the board adjaxcent to the memory socket.
If no joy either try your memory in another PC or try a known good stick in your PC

 

Have you tried saving the BIOS settings? Go through the BIOS or set it to defaults and save that.
If nothing, maybe ram, but you usually get a message on that.

 

bot up problem

To Peanut,

Thank you for your answer.Will follow your instructio9ns and let you know the results.

Jerry

To Mark,

I can not get to the BIOS.It seems that everything is locked out.

Jerry

 

Peanut,

I reseated the RAM modules as instructed.I got 3 beeps.So I removed them completely and I got the same 3 beeps.Therefore I think I have bad Rams.I will replace them tomorrow and let you know.Thanks.

Jerry

 

Beep Codes

 

bootup problem

Peanut,

Finally I had a chance to check the RAM in another computer.They worked fine.After reinstaling them in the computer having the bootup problem,same conditions exist:3 beeps and the Screen says :CHECKING NVRAM,and stays there.

Jerry