1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

Resolved Case Fan - install which way?

Discussion in 'PC Hardware' started by jparnold, 2009/09/15.

  1. 2009/09/15
    jparnold

    jparnold Inactive Thread Starter

    Joined:
    2005/09/08
    Messages:
    345
    Likes Received:
    1
    I have decided to install a 12cm case fan in my new 2.93Mhz Pentium 2 Duo with Gigabyte GA-EG41MF-US2H motherboard PC.
    I have noticed that while the CPU doesn't get very warm the heat sink on the G41 Intel chip on the motherboard gets quite warm (is this normal?).

    Is there a preferred direction for the fan to blow the air - blow the air INTO the case or blow the air OUT of the case?

    I guess the thermal change isn't much different but what about dust getting into the case?

    Thanks
     
  2. 2009/09/15
    demon

    demon Well-Known Member

    Joined:
    2002/03/23
    Messages:
    295
    Likes Received:
    2
    Hi, on mine they are extracting the hot air, then it draws cold air into the case which is not being drawn over the fan motor.
    Cheers des.
     

  3. to hide this advert.

  4. 2009/09/15
    jparnold

    jparnold Inactive Thread Starter

    Joined:
    2005/09/08
    Messages:
    345
    Likes Received:
    1
    Thanks for the quick reply.

    It's a pity that case manufacturers don't make sealed cases (apart from where case fans are installed) so that you can add an air filter (such as on an air conditioner) as it's incredible how much dust gets inside which can cause problems.
     
  5. 2009/09/15
    PeteC

    PeteC SuperGeek Staff

    Joined:
    2002/05/10
    Messages:
    28,896
    Likes Received:
    389
    A number of the upmarket cases have an inlet air filter - fine gauze. My Antec Sonata does and stays clean internally over long periods - I guess I dedust annually.

    Clearly a need to balance the degree of filtration with the power of the fan - case fans really only shift air rather than pump air. Fine filtration would require a powerful - and noisy, volt hungry fan which would drown out all other noise and be a constant irritant :)

    Most effective cooling is air drawn in the front and exhausted out of the back as demon posted.

    I've marked this thread as 'Resolved', please see .....
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.