1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

f1 key bios boot dell 8200

Discussion in 'PC Hardware' started by larkin, 2008/07/29.

  1. 2008/07/29
    larkin

    larkin Inactive Thread Starter

    Joined:
    2002/01/07
    Messages:
    138
    Likes Received:
    0
    Hi, a client has a Dell Dimension 8200 tower dating from 2002. 1.8 MHz CPU, 533 MHz bus, 1G RAM. I had to swap out a bad HD for a new one. While enroute to that, w/old drive still in PC & I'm still seeing if I can recover data, on BIOS boot, the screen dialog stops at "can't find primary drive" "hit F1 to continue" [choice 1" , or [choice 2:] "hit F12 to enter setup ". So now on boot, client has to still hit F1 to continue successful boot to wXPhome-sp2. This doesn't make sense to me, it never happened before his old drive went bad. Is there a way to continue the BIOS boot without this message? The drive is obviously found & booted to. Is this a battery problem? Is this a sign of an upcoming mobo failure? CMOS or boot instruction problem?
    Should fdisk/mbr fix this (this seems not so to me, because boot hasn't reached windows yet, the drive is supposedly not yet found)? Would flashing the BIOS to lastest available, fix this (don't know if there is a more recent BIOS)? Bad cable?

    Thank you.
     
    larkin,
    #1
  2. 2008/07/29
    BurrWalnut

    BurrWalnut Well-Known Member Alumni

    Joined:
    2003/03/05
    Messages:
    628
    Likes Received:
    8
    Could it be that during the HDD change, you omitted to reconnect (or dislodged) the FDD cable and the FDD is ahead of the HDD in the BIOS boot sequence?
     
    Last edited: 2008/07/29
    BurrWalnut,
    #2


  3. to hide this advert.

  4. 2008/07/31
    TonyT

    TonyT SuperGeek Staff

    Joined:
    2002/01/18
    Messages:
    9,072
    Likes Received:
    400
    1. remove old drive.
    2. set jumper on new drive to master on channel 1, boot directly to bios & verify bios sees drive.
    3. boot to windows.
    4. shutdown, set jumper on new drive to master w/ slave, connect old drive and set jumper as slave.
    5. boot directly to bios & verify bios detect both drives & that boot order is correct.
    6. boot to windows.

    note: some drives have only 3 jumper settings, master, slave, cable select, while others have master (single), master w/ slave, slave & cable select.

    If using sata drives, boot with only the new drive. Then shutdown and add the old one. Likely not using sata though as that system does not have onboard sata ports.
     
    TonyT,
    #3

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...