1. You are viewing our forum as a guest. For full access please Register. WindowsBBS.com is completely free, paid for by advertisers and donations.

fault diagonasis of netword card routeprint command

Discussion in 'Networking (Hardware & Software)' started by panchal, 2008/01/11.

  1. 2008/01/11
    panchal

    panchal Inactive Thread Starter

    Joined:
    2002/05/21
    Messages:
    122
    Likes Received:
    0
    I have issue of NETWORK CARD , WHEN CONNECTED TO BROADBAND I AM NOT ABLE TO LOG;
    i went through series of diagonosis to check hardware of my Network Card , one of them is to enter command in DOS " ROUTEPRINT" , but when i do so it says it is not recognized as internal or external command whereas if i type same command in my other PC , it displays addresses.
    Is it that my Network card is faulty??
    all above is carrried out after disconnecting LAN cable
    Does anyone know software to fault diagonize network card?
     
    panchal,
    #1
  2. 2008/01/11
    Steve R Jones

    Steve R Jones SuperGeek Staff

    Joined:
    2001/12/30
    Messages:
    12,315
    Likes Received:
    252
    At the command prompt type:

    Route /? to see the options for the route command.
     
    Steve R Jones,
    #2


  3. to hide this advert.

  4. 2008/01/11
    panchal

    panchal Inactive Thread Starter

    Joined:
    2002/05/21
    Messages:
    122
    Likes Received:
    0
    thanks reply

    Hi steve,
    Thanks, for information, actually I want to now know that how to enable DHCP to automatically configure IP address in TCP/IP as whenever i try to connect BROADBAND I am require to add IP address manually as it doesn't find auto even I have selected auto option
     
    panchal,
    #3
  5. 2008/01/12
    TonyT

    TonyT SuperGeek Staff

    Joined:
    2002/01/18
    Messages:
    9,072
    Likes Received:
    400
    To use auto dhcp in XP:
    If use a router make sure the router dhcp is enabled.
    Set net card TCP to use auto.
    Next, go to control panel > admin tools > services >
    Make sure the following Services are set to:
    DHCP Client > auto started
    Network Connections > manual started
    Network Location Awareness > manual started
    reboot comp

    If don't use a router, config as above, power off the broadband modem completely.
    Shutdown comp.
    Power on modem & wait until synched.
    Power on comp.
     
    TonyT,
    #4

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...